Choosing the wire clamp microdrive for termosonic microwelding equipments

  • V. L. Lanin Belarusian State University of Informatics and Radioelectronics, Minsk, Belarus
  • I. B. Petukhov DDPEE-CO, Minsk, Belarus
  • V. V. Shevtsov DDPEE-CO, Minsk, Belarus
Keywords: microdrive, wire feeder, thermosonic microwelding

Abstract

The article describes research of three types of wire clamp microdrive for thermosonic microwelding equipment, covering an expanded range microconductors from 12,5 up to 75 mm. The most preferable, in the light of their high-speed and easy-programming qualities, proved to be the mechanisms of conductor clamp with piezoelement drives and the loading system based on "voice-coil" type electromagnet.

Published
2010-06-28
How to Cite
Lanin, V. L., Petukhov, I. B., & Shevtsov, V. V. (2010). Choosing the wire clamp microdrive for termosonic microwelding equipments. Technology and Design in Electronic Equipment, (3), 54-57. Retrieved from https://tkea.com.ua/index.php/journal/article/view/TKEA2010.3.54
Issue
No. 3 (2010): Tekhnologiya i konstruirovanie v elektronnoi apparature
Section
Articles

Copyright (c) 2010 Lanin V. L., Petukhov I. B., Shevtsov V. V.

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.